HOW TO INSTALL A BATTERY
Read and follow the Safety and Handling information on this website.
Clean the tray where the battery rests. Use steel wool or a wire brush to rub the metal clamps and remove any corrosion.
Place your new battery in the battery tray (make sure your battery is
fully charged). Make sure it faces the proper direction so that the
positive and negative terminals line up with their corresponding cables.
Secure the hold-down strap in its original position over the new
battery, ensuring it is properly secure to prevent movement or vibration
wear. Do not tighten the hold-down bracket too hard, since this can
damage the plastic case and cover.
Attach both cables. Attach the positive (red) cable first, following with the negative (black) cable.
Hand-tighten the nuts. Do not over tighten the terminal bolts; the following values are recommended:
SAE (tapered) automotive terminal: 50 to 70 inch-lb.
Side terminal (3/89 nut): 70 to 90 inch-lb.
Threaded stud terminal: 120 to 180 inch-lb.
OTHER BATTERY INSTALLATION TIPS
Check mounting surface for objects or protrusions that could cause
damage or wear to the case or cover. The battery must be level in the
tray. Make sure there are no foreign objects in the tray that could
damage the battery.
Replace cables and connectors that show signs of corrosion, rust or other damage.
Do not lift or handle the battery by its terminals.
If using a dual-terminal battery (it has both top and side terminals),
use top terminals for accessory hookups and vehicle starting. Only use
battery side terminals for vehicle starting.
Check for proper battery polarity with respect to vehicle
specifications. “Ground” polarity is typically indicated. “Reversed”
polarity can cause serious damage to your vehicle’s electrical system.
The hold-down should be tightened so that it is snug.
Top bar or top frame hold-down: 30 to 50 inch-lb.
Bottom recess hold-down: 60 to 80 inch-lb.
Bottom ledge-type hold-down: 70 to 90 inch-lb.
Caution: Some vehicles equipped with advanced electrical systems may
require special handling procedures. Please refer to your owner’s manual
for details.
One of the most frustrating experiences you can have is when you start your car…
We all know that battery corrosion or dirt could cause some parasite draws when the…
Let me show you how to replace the battery without actually disconnecting it from the…
Whether you need to recharge a car battery after it has been sitting in storage…
Battery Groups Description On the surface, most Lead-Acid or AGM batteries appear to be similar.…
The small round table in the dinette may be great for casual meals with your…